JWSR LLCCall 862-268-2510Call now

Backwater valves and sewer backups

A backwater valve keeps sewage from coming back up from the town main. It does not fix a clogged or broken pipe in your own line. Here is which is which.

A backwater valve is a one-way valve on your sewer line. It helps when sewage pushes back from the main. It does not help when the problem is a clog or a failed pipe on your side, and it needs regular upkeep. Permits and code vary by town, so check with yours first.

What a backwater valve does

It sits on the line that carries waste out of the house. Normal flow pushes a flap open and out. If flow reverses, the flap closes and holds it back. They are usually placed low on the line, before it leaves the house.

When it helps

Sewage coming back from the town main

When the main in the street fills up, for example in heavy rain, flow can reverse and push back up your lateral. A valve closes against that and keeps it out of the house.

Fixtures low in the house

Basement floor drains, a basement bath or a laundry sink sit lowest, so they are where a backup shows up first.

When it does not

A clog or break in your own line

The valve only lets flow go one way, out of the house. If the blockage is on the house side of it, water has nowhere to go and still backs up into the house. That is a clearing job, or a pipe repair if the line has failed.

A valve that is stuck or dirty

It is a mechanical part that works in waste. One that is jammed open does nothing, and one that is jammed shut can keep your own drains from leaving.

If your line backs up again after being cleared, that is the pipe, not the main. Start with our sewer backup guide, and a camera inspection ($300 with a cleanout, $500 if a toilet must be pulled) shows what the line is doing. A free estimate is available if you already know the work you want. If the line has to be diagnosed first, that visit is paid and the fee comes off the job if you hire us.

Keeping it working

Look at it on a schedule

A valve is a moving part in a dirty pipe, so it needs regular checks and cleaning. Ask whoever installs yours how often, and put it on the calendar.

Make sure the flap moves freely

Most have an access cover. With it off, the flap should swing without sticking and the seat should be clear of debris.

Know where it is

It usually sits on the lateral where it leaves the house, often in a pit or box in the basement floor. Keep stuff off the cover so it can be reached.

Mind the pipe on the house side

A valve does not replace a clean line. Roots, grease and a low spot still cause backups on the house side.

Permits and code: check with your town

Whether a valve is required, which type is allowed, and whether it needs a permit all vary by town and sewer authority. Call your town's construction or plumbing office before anyone installs one, and ask who is responsible for the line between the house and the main. Our sewer lateral guide covers ownership and permits for the pipe itself, and our sewer lateral repair and replacement page describes the work on that pipe.

Common questions

What does a backwater valve do?

It is a one-way valve on the sewer line leaving your house. Waste flows out normally. If flow reverses from the town main, a flap closes and keeps sewage from coming back up into your drains.

Will a backwater valve stop every sewer backup?

No. It protects against flow coming back from the main. It does nothing for a clog, roots or a collapsed section on the house side of the valve, and those still back up into the house.

Does a backwater valve need maintenance?

Yes. The flap and seat sit in waste, so they need regular checks and cleaning. Open the access cover and confirm the flap swings freely and is free of debris. Ask your installer how often.

Do I need a permit or does code require one?

It varies. Permit rules, whether a valve is required, and which type is allowed differ by town and sewer authority. Call your town's construction or plumbing office before anything is installed.

My sewer is backing up right now. Should I buy a valve?

Not first. Stop water use, then work out whether it is a clog or a failed pipe, because a valve will not fix either. Our sewer backup page walks through that.

How it works

Three steps, no runaround

Step 1

Call or send the form

Call us at 862-268-2510, or tell us about the job online. Emergencies jump the line.

Step 2

Free estimates when you know what you want done

We look at the ground, tell you straight what it needs, and give you a fair, upfront price. When we have to find the problem or design the fix (camera inspection, site evaluation, design), that's a paid visit, credited toward the job if you hire us.

Step 3

We do the work

Markouts and permits handled. We dig, backfill, restore, and walk the finished job with you.

Licensed & insuredLicensed NJ home improvement contractor (HIC #13VH11072100), fully insured.
Local & family ownedBased in Hamburg, NJ
Working in the area since 2016Our own crews and equipment
811 called every jobWe wait for the marks before digging
5.0 on Google111 reviews
Recent work

Real jobs by our own crew

Worker in a hi-vis vest and hard hat with a small tool near a tree on a lawnNarrow open trench along a road edge with a mini excavator and orange marker flagsBlack conduit laid in an open trench along a yellow house, with a worker in a hi-vis vest behind itBlack conduit in a trench at the edge of a fenced yard beside a houseRound access hole cut into pavement on a residential street with an excavator and a worker nearbyWork truck and mini excavator on a road beside an open trench and orange marker flags

See all our work →

Not sure if it is the main or your line?

Call 862-268-2510. We will tell you what the pipe needs.

Call 862-268-2510Get an estimate