JWSR LLCCall 862-268-2510Call now

Trenching in North Jersey

Power to the garage, a water line, a sewer lateral, a drain. Our own crew digs the trench, beds it, backfills it and puts the yard back.

We dig trenches for electric, water, sewer, drainage and data lines across seven North Jersey counties. A licensed electrician or plumber makes the connections and pulls the permits. We call 811, dig, bed, backfill and restore the surface. Pricing is a set written price after we see the route.

What we trench for

Electric to a garage, shed, pool equipment, EV charger, generator or well

We dig, bed and backfill. A licensed electrician designs the circuit, pulls the permit and makes every connection.

Depths and who does what

Conduit for data, internet and fiber

Empty conduit for internet or low-voltage lines is cheap while the trench is open. We also place fiber and telecom conduit for providers.

Fiber and telecom conduit

Water service lines

A new or replacement water service from the main or a well to the house, at the depth your water utility and town call for.

Water service replacement

Sewer laterals

Open-cut trenching for a new or replacement sewer lateral, bedded and graded to pitch.

Sewer lateral replacement

Drainage and French drains

Trenches for footing drains, French drains, downspout runs and yard drainage, with stone and pipe set to grade.

French drain installation

Utility construction

Longer runs for water, sewer and storm, for homeowners, HOAs and contractors.

Utility construction

How deep does the trench go?

The depth comes from what is going in the ground, and the person who designs that line sets it. For electric, the National Electrical Code (Table 300.5, adopted in New Jersey at N.J.A.C. 5:23-3.16) sets minimum cover. Cover is measured from the top of the cable or conduit to finished grade, not from the bottom of the trench.

Wiring methodMinimum cover
Direct burial cable (such as UF)24 inches
Nonmetallic conduit (PVC), no concrete cover18 inches
Rigid metal or intermediate metal conduit6 inches
120 V, 20 A or less residential branch circuit with GFCI12 inches

Driveways, buildings, streets and the point where the wire comes up out of the ground have their own rules. Your electrician and the local electrical inspector set the exact depth for your job. Check the table against the code edition in force when the permit is pulled.

Water is different. Frost depth is set locally in New Jersey, and your water utility and town decide how deep a service goes. For a combined domestic and fire service, the plumbing subcode (N.J.A.C. 5:23-3.15) calls for 42 inches of cover or 12 inches below local frost depth, whichever is greater. Ask your utility and construction office before anything is dug. Our shallow water line page goes further into frost depth.

Call 811 first

Before any digging, a New Jersey One Call (811) ticket gets the public utilities to mark their lines. We do not dig without one, and we hand dig within 24 inches of a mark. Private lines such as irrigation, a dog fence, lighting or a private water run are not marked, so tell us what you know is down there. The rules are on our NJ utility damage law page.

Who does what

Licensed electrician or plumber

Designs the line, sets the wiring or pipe method, pulls the permit, installs the conductors or pipe, makes the connections and schedules the inspection.

JWSR

Files the 811 request, digs to the depth and route specified, beds the line, backfills in layers, compacts and restores the surface.

We do not install conductors, make connections or pull electrical permits. The full split is in who digs the trench for an electrician and trenching power to a garage, shed or EV charger. Need help lining up the trades? Call and tell us what you have. Our underground power and data page covers the power side.

Putting the yard back

Topsoil is stripped and set aside, the trench is backfilled in layers and compacted, and the topsoil goes back on top. Lawn is seeded with our own 500-gallon hydroseeder, so the seed and the dig come from the same crew. A driveway or walkway can be cut and patched, or crossed without cutting by directional boring. Trenchless or open cut explains how that choice is made. See hydroseeding for the seeding step.

Photos from our jobs

Narrow open trench in dirt and gravel running toward a small excavator and a barn
Open trench in dirt and gravel with a mini excavator at the far end.
Open trench with a pile of orange soil beside it, cut across a grass lawn
Open trench running across a lawn.
Long open dirt trench beside a paver patio with a shovel leaning in it
Open trench along the edge of a paver patio.

How we price a trench

We do not use a per-foot price, because length is only part of it. Depth, soil, ledge rock, what is on the surface and how far the dig is from the equipment all move the number. If you know what you want done, the estimate is free, and the owner or a senior supervisor comes out for every estimate. If the problem needs to be found first, the visit is a paid diagnostic visit, with the fee credited toward the job if you hire JWSR. Routine work gets a set written price, with allowances for unknowns like rock. There is no travel charge. After-hours and emergency rates apply. More on how we price.

Where we trench

We work in Sussex, Warren, Morris, Hunterdon, Somerset, Passaic, Bergen counties in New Jersey. See service areas for your town. For sewer and water mains, see water and sewer mains and sewer and water lines. For a broader look at digging, see excavation.

Planning to bury a storm shelter or safe room? That is a bigger excavation. See excavation for an underground shelter.

Common questions

How much does trenching cost?

It depends on length, depth, soil, what is on top (lawn, driveway, walkway) and whether there is rock. We do not quote a per-foot price over the phone. We give a set written price after we see the route, with allowances for unknowns like rock. If you know what you want done, the estimate is free. If we need to look into the problem first, the visit is a paid diagnostic visit, and the fee is credited toward the job if you hire us.

How deep does a trench for electric have to be?

It depends on how the wire is run, and your electrician and the local electrical inspector set it. The National Electrical Code, Table 300.5, gives minimum cover of 24 inches for direct burial cable, 18 inches for PVC conduit, 6 inches for rigid metal conduit and 12 inches for a small GFCI-protected residential branch circuit. Driveways, buildings and streets have different rules. Cover is measured from the top of the cable or conduit to finished grade.

Do you call 811 before digging?

Yes. We do not dig without a New Jersey One Call (811) ticket, so the utilities mark their lines first. Within 24 inches of a marked line the digging is done by hand. The markout covers public utilities only. Private lines, such as an irrigation line, a dog fence or a private water or electric run, are not marked, so tell us what you know is buried.

Do you run the wire or the pipe?

Connections are done by the licensed trade. A licensed electrician installs conductors, makes connections and pulls the electrical permit. A licensed plumber makes the plumbing connections and pulls the plumbing permit. We dig the trench to the depth and route they specify, bed it, backfill and compact it, and restore the surface. Some electricians ask us to place the conduit under their direction. Agree on that before the crew arrives.

What happens to my lawn or driveway?

Topsoil is set aside and put back on top, and the trench is backfilled in layers and compacted so it does not sink. We seed with our own 500-gallon hydroseeder. A driveway or walkway crossing can be cut and patched, or crossed by directional boring to avoid cutting it. See directional boring and trenchless or open cut for how that choice is made.

Do you do gas lines?

No. We do not install gas or propane lines. If your project needs one, the gas utility or a licensed plumber or gas fitter handles it. We can dig the trench for your electric, water, sewer, drainage or data line.

General information from an excavation contractor, not legal advice. Your electrician, plumber, utility and local code officials decide what applies to your job.

How it works

Three steps, no runaround

Step 1

Call or send the form

Call us at 862-268-2510, or tell us about the job online. Emergencies jump the line.

Step 2

Free estimates when you know what you want done

We look at the ground, tell you straight what it needs, and give you a fair, upfront price. When we have to find the problem or design the fix (camera inspection, site evaluation, design), that's a paid visit, credited toward the job if you hire us.

Step 3

We do the work

Markouts and permits handled. We dig, backfill, restore, and walk the finished job with you.

Licensed & insuredLicensed NJ home improvement contractor (HIC #13VH11072100), fully insured.
Local & family ownedBased in Hamburg, NJ
Working in the area since 2016Our own crews and equipment
811 called every jobWe wait for the marks before digging
5.0 on Google111 reviews
Recent work

Real jobs by our own crew

Two workers in hi-vis vests beside a mini excavator digging on a lawnOrange mini excavator on a lawn edge beside a paver walkway, with a worker standing byOrange mini excavator on a pile of crushed stoneOrange mini excavator on a pile of crushed stone under treesOrange mini excavator on a pile of crushed stone beside treesMini excavator on a lawn beside a lake shoreline

See all our work →

Need a trench dug?

Tell us what is going in the ground. Free estimate when you know what you want done. Call 862-268-2510.

Call 862-268-2510
Get an estimate

A minute of details now means we can price the work and book the visit without calling you back for them.

Not sure what's wrong? Tell us what you're seeing and we'll tell you what we think.

What happens next
  1. We aim to call you back within the hour.
  2. We ask a few questions and set a time.
  3. You get a written price. It's free when the job is defined. If we need to diagnose first, that's a paid visit, credited toward the job if you hire us.

No obligation. Or call 862-268-2510.

Call 862-268-2510Get an estimate